Jump to content
AutoDesSys

Centre edge transparency


Sammi

Recommended Posts

Hi guys

 

I have started to work with a centre edge transparency

- the real life photo in the bottom right hand corner is what I am trying to recreate -

 

is there a way to blend the edge of my 'tube' more so it looks more of a graduated colour going up the wall?

 

I am going to difference my 'tube' from the back wall too

 

Thanks for any help

Sammi  :) post-954-0-68195700-1426593183_thumb.jpg

Link to comment
Share on other sites

My initial suggestion would be to use 'neon' rather than centre edge and I would probably extrude an oval rather than a circle to make the 'tubes' - I'm not sure how the centre edge/neon will work once you had differenced them? You could try a linelight but this will obviously take longer to render.

 

Personally I would cheat and do this in photoshop - do each wall as a complete graphic and put the glow over the top - this will render much quicker.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...