Steve003 Posted May 6, 2016 Share Posted May 6, 2016 Hi Form Z jr Wish to snap to quads on a circle, but where is the command ? Steve Link to comment Share on other sites More sharing options...
Tech Posted May 7, 2016 Share Posted May 7, 2016 Hi Steve, Right click on the Object Snaps and choose Snap Options. Then set the Interval Snap to 4 divisions: Does that do what you want? Link to comment Share on other sites More sharing options...
Steve003 Posted May 7, 2016 Author Share Posted May 7, 2016 Hi, which of the snap options do I right click on, snap to point or snap to tangent or etc etc ? I have set snap to point to 4 divs but its not doing it for me, prior I chose another, not sure which one now, I think the tangent one, and was getting 4 options on a cylinder edge. I wish it to seek out the 4 quad points of an imported circular wheel hub, from Rhino3D, and ignore all other snaps. I am familiar with that prog and one can right click on quad osnap and turn all other snaps off, it then snaps to only quads on a circle, and says quad as it does so. Steve Link to comment Share on other sites More sharing options...
Tech Posted May 8, 2016 Share Posted May 8, 2016 Hi Steve, You only need the Snap to Interval active, and you can right click on any Object Snap, or choose Snap Options from the Palette Menu: Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.