Guest seasdes Posted April 30, 2017 Share Posted April 30, 2017 I find that the original points remain if I say draw a wall then lengthen the wall using the Reshape tool. Is there a way to stop this from happening. I have looked up the manual and looked at the Reshape tools tutorial. Link to comment Share on other sites More sharing options...
FZnoob Posted May 1, 2017 Share Posted May 1, 2017 Do you have "keep edges" selected in the "tool options" pallet? Link to comment Share on other sites More sharing options...
Guest seasdes Posted May 1, 2017 Share Posted May 1, 2017 Do you have "keep edges" selected in the "tool options" pallet? No 'Keep edges' are toggled off. Link to comment Share on other sites More sharing options...
Tech Posted May 1, 2017 Share Posted May 1, 2017 Seasdes, Have you checked the geometry with the Object Doctor? Perhaps this is some bad geometry that is causing coplanar faces / edges when the object is reshaped. Please post a simplified version your file that still shows the problem or send it to support@formz.com so we can further assist you. Link to comment Share on other sites More sharing options...
Guest seasdes Posted May 1, 2017 Share Posted May 1, 2017 Object Doctor fixes the problem. However if I create a new wall and reshape it the problem reappears. I will send a model by email. Link to comment Share on other sites More sharing options...
Bo Atkinson Posted May 2, 2017 Share Posted May 2, 2017 I don't have formZ on this computer, but in some cases, the Unmesh tool has helped me with Reshape products in the past. Regardless that a mesh condition was not visible to me. (?) Link to comment Share on other sites More sharing options...
Tech Posted May 5, 2017 Share Posted May 5, 2017 seasdes, Thanks for sending your file. This seems to be a redraw problem when the Show Points option is active in the Display Options. If this is turned off, this should no longer be a problem. We will get this corrected. Link to comment Share on other sites More sharing options...
Guest seasdes Posted May 5, 2017 Share Posted May 5, 2017 Thanks for your help Tech Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.