setz Posted September 22, 2016 Share Posted September 22, 2016 I find myself fishing around for the center of a face and at times when there are a number of faces to which the snap could be applied to, I am not sure as to which one actually is being snapped to. I have two suggestions: One - That the whole face to which the center is snapped is highlighted in some way so that the wrong face is not snapped to by accident when there are many faces to which the snapping could be acting. Two - That "Stick to Edges" which is a sort of snap-to-the-snap function would work with Center of Face as well. The center would be snapped to any time the mouse was over any portion of that face. Both these behaviors were present in V6 and snapping to the center of a face was considerably more efficient with them. Link to comment Share on other sites More sharing options...
¢hris £und Posted September 22, 2016 Share Posted September 22, 2016 +1 Link to comment Share on other sites More sharing options...
ZTEK Posted September 22, 2016 Share Posted September 22, 2016 +1 Link to comment Share on other sites More sharing options...
Andy Posted September 23, 2016 Share Posted September 23, 2016 +1 Link to comment Share on other sites More sharing options...
Des Posted September 23, 2016 Share Posted September 23, 2016 +1 Link to comment Share on other sites More sharing options...
pylon Posted September 23, 2016 Share Posted September 23, 2016 +1 Link to comment Share on other sites More sharing options...
Alan Cooper Posted September 25, 2016 Share Posted September 25, 2016 Maybe hitting the tab key could cycle through highlighting the nearest options available. Link to comment Share on other sites More sharing options...
Jaakko Posted October 13, 2016 Share Posted October 13, 2016 +1 Link to comment Share on other sites More sharing options...
Hugo Posted October 16, 2016 Share Posted October 16, 2016 +1 Link to comment Share on other sites More sharing options...
DennisA Posted October 16, 2016 Share Posted October 16, 2016 +1 Link to comment Share on other sites More sharing options...
Andrew West Posted November 26, 2016 Share Posted November 26, 2016 I would also like to see the old option from 6.7 to snap to the back points of an object while in elevation or plan view. Right now snap to point locks the snap only to the front points by default. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.