Jump to content
AutoDesSys

Insert Segment Tool & Snapping


kmwhitt

Recommended Posts

Trying to insert a segment from midpoint to midpoint of polygon.  It is not possible to snap to points indicated.  It doesn't work on the cube either.  If I draw with the vector line tool with insert "on", I am able to get the snaps to work.  I would assume the operation of both tools would work the same?

Untitled5.zip

Link to comment
Share on other sites

It works better when I disable the large cursor.  When the large cursor is in use, I have to offset its position {while hovering} quite a bit for FMZ to acknowledge the snap point.  It is difficult to get just the right spot.  Try it with the large cursor enabled and see if you're getting the same result.  Thanks.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...