Jump to content
AutoDesSys

Layout frames content now showing after sync


AsOne

Recommended Posts

I'm new working in Layout.  I setup a Layout file with several frames.  The frames have views showing elevations of my 3D model.  

 

I go back into FormZ, make changes to my model, and it resync's in Layout when I go back to Layout.  

 

So far so good, but...now all the frames show nothing.  If I try to export as DWG file there is nothing there.  However, after exporting the DWG or after closing the Layout file and reopening everything is back in the frames as it should be.  

 

Is there some "refresh" frame button somewhere?  I don't want to have to save, close, and reopen the file after every sync.

 

Thanks

Link to comment
Share on other sites

  • 2 weeks later...

You should avoid Layout, because it is to limited, no control over the drawing etc. Etc.

Many things already said about layout on the forum. Unfortunately...

 

Hopefully ADS next version will be better.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...