Jump to content
AutoDesSys

transformation modifiers specific to each tool


snow

Recommended Posts

I would like to see transformation modifiers become tool-specific.  

 

If I need to make X copies of something I'll use the move tool to do this.  Then if I want to rotate one of these items the modifier is still on multi-copy, not self.  This has caused more problems and slow-down than good while modeling.

Link to comment
Share on other sites

Similarly, I would like to see these options NOT carry over from project to project.

 

If I need to make a wire grid I will often quickly open a new project draw out my rectangle, then use multi-copy on the segments to achieve my wire grid (this can put the multi-copy in the teens, twenties, thirties, etc.).  After using the frame and union tool, then I quickly select all, copy, switch project, paste, and when I just try to MOVE (using a key shortcut) the single wire grid formZ will start to make 32 copies of it... which will bog it down and I have to tap Escape a number of times/switch to Picker and then sit for 2 minutes to cancel the request. 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...