Imagix Posted August 31, 2017 Share Posted August 31, 2017 This is a 4 seconds SL16 render... http://www.imagix.dk/ftp/sequence_01.mp4 It's been cropped to show a darker portion of the image that has quite a bit of flickering! There is noise too, but that's expected and can be reduced using a different lighting setup. Question is... What's causing the flickering and how do I avoid it? Maybe... - meshing the floor plane - not using grass for the carpet - avoiding specific light types - anything else Recommendations much appreciated!! Thanks Anders (PS I posted this on the Maxwell render forums as well, but decided to post here as well in case it's a formZ+Maxwell thing) Link to comment Share on other sites More sharing options...
pylon Posted August 31, 2017 Share Posted August 31, 2017 Anders, I've not seen that before. If you can send a reduced formZ project file that reproduces the issue, I'd be happy to take a look. Link to comment Share on other sites More sharing options...
Imagix Posted August 31, 2017 Author Share Posted August 31, 2017 The animation was done on Rebusfarm. I had a high limit (200 euros) on the render but it seems it wasn't enough. I think it varied how high SL each frame reached and that caused the flickering. I did the same render on another farm today with no ceiling. It reached SL16 (25 frames). They all look clean and even. Link to comment Share on other sites More sharing options...
pylon Posted September 1, 2017 Share Posted September 1, 2017 That would explain it. I'm glad you got it sorted out. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.