Jump to content
AutoDesSys

Creating Egg and dart - cannot perform Booleen operation?


Spacer

Recommended Posts

Hi ,

 

in this model I cannot use the solid "bool egg 4" to subtract from "Egg and Dart Base 4"(also a solid) without the result become a Surface object.

I had just previously performed a meshed reduce on all of these, FYI,but object doctor says all good.

 

As you can see, I did perform a successful booleen with solid result on the very same object (blue)

 

I need a solid result in order to round the edge of the hole produced, in which the egg will nest.

 

My modelling strategy may not bethe best, but I don't know if there is a "Classical Language of Architecture" Parametric tool (wish list - Vitruvius would love it!)

 

Thanks ,

 

peter

 

bool egg and dart problem.fmz.zip

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...