HoneyDear Posted January 20, 2017 Share Posted January 20, 2017 I am importing a plat map from the engineer and I want to turn the linework into a solid or a surface can be reshaped. Do I have to trace over every line to make that happen or is there a tool that does that? martin way site -clean.zip Link to comment Share on other sites More sharing options...
Tech Posted January 20, 2017 Share Posted January 20, 2017 HoneyDear, Closed shapes will extrude to solids, so if you get the Join tool from the Line Editing tool row, select all, and click in the screen, then you should be well on your way to using these lines directly with only minimal additional cleanup. Does that get you going in the right direction? Link to comment Share on other sites More sharing options...
Andrew West Posted January 20, 2017 Share Posted January 20, 2017 I have had a lot of experience with importing platt maps. The process can be as simple as joining the lines which always seem to be broken in places. However, it is important to check the SHOW DIRECTION box in your display palette. All the lines need to be pointed in the same direction before you can do anything with them. Link to comment Share on other sites More sharing options...
HoneyDear Posted January 20, 2017 Author Share Posted January 20, 2017 Thank you for the response. That doesn't seem to be working. When I am getting the "o" with a line through it. Link to comment Share on other sites More sharing options...
darwin06 Posted January 20, 2017 Share Posted January 20, 2017 I had some luck joining individual segments one at a time or by shift-picking them so I had more control over what becomes a surface without getting any bad geometry. Link to comment Share on other sites More sharing options...
HoneyDear Posted January 21, 2017 Author Share Posted January 21, 2017 I had some luck joining individual segments one at a time or by shift-picking them so I had more control over what becomes a surface without getting any bad geometry. Oh wow. I am a noob. I have no idead what you just said. LOL Link to comment Share on other sites More sharing options...
Tech Posted January 26, 2017 Share Posted January 26, 2017 HoneyDear, With the Pick tool active, you can hold down the Shift key and select each segment that you want to join together, then use the Join tool to make them a single curve/surface. Perhaps this tutorial video about Picking will help: http://www.formz.com/Video/formZ/formz7_ENU/videos_html/Picking.html Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.