Jacky1972.21mm Posted August 28, 2015 Share Posted August 28, 2015 Hi Tech, I'm just purchased Maxwell render v3, i need launch Maxwell render from formZ, i push Maxwell render botton (red arrow) but it don't work. No function at all. Please help. Thanks Jacky Link to comment Share on other sites More sharing options...
pointer Posted August 28, 2015 Share Posted August 28, 2015 Do you have any lighting in the scene? try adding a Sky Dome, Physical Sky or a IBL (Image based lighting) if not. Link to comment Share on other sites More sharing options...
Tech Posted August 28, 2015 Share Posted August 28, 2015 Hi Jacky, We are not sure why this would not work, and we are not sure why this would happen. You should post Maxwell Render questions in the Maxwell Render section of our forum. We will move your post there so it can be answered by others. Link to comment Share on other sites More sharing options...
pylon Posted August 28, 2015 Share Posted August 28, 2015 Hi Jacky, Welcome aboard, we will get you headed in the right direction. Make sure you have installed according to the instructions here: http://support.nextlimit.com/pages/viewpage.action?pageId=16810281 Try a test render as follows: http://support.nextlimit.com/pages/viewpage.action?pageId=16810282 If there seems to be a problem after attempting a rendering, check the Maxwell Log. Select Extensions > Maxwell Render > Log. Look for warnings and errors. With the Log as a guide, you can troubleshoot most issues yourself. If you cannot find the source of the problem in the Log, click on "Save Log" and save to your Desktop or other convenient location, then post the resulting log here, or send it to Link to comment Share on other sites More sharing options...
Jacky1972.21mm Posted September 1, 2015 Author Share Posted September 1, 2015 Dear All, Finally, i found my problem at Troubleshooting chapter, i set my "get info" to open with Maxwell Studio, thank you everyone. Thanks a lot. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.